The Talend Identity and Access Management RPM uses a set of parameters to perform the installation.
To use custom values, set up these parameters in environment variables before performing the installation.
|TALEND_INSTALL_USER||talend||This user is set as the owner of base folder for the package. The user is created if missing.|
|TALEND_INSTALL_GROUP||talend||This group is set as the owner of base folder for the package. The group is created if missing.|
|TALEND_INSTALL_SYSTEMD||1||Whether to install SystemD services. Possible values are 0 (false) or 1 (true). Services are created and enabled, but not started.|
|TALEND_TOMCAT_HOME||$(TALEND_INSTALL_PREFIX)/tomcat||Base folder of Tomcat which will be used for deployment. It can be provided by Talend (RPM), or a custom Tomcat.|
|TALEND_TOMCAT_MODE||shared||Specifies if Tomcat should be used as a master Tomcat (shared) or
directly by the current application (direct). Possible values are
shared or direct.
Each Talend application relying on Tomcat requires a distinct Tomcat with different settings. The Tomcat RPM package provided by Talend cannot be installed more that once in parallel. For that reason, you must use the shared mode to use it as a master Tomcat, unless you already have installed a dedicated Tomcat for each application. In the latter case, you can use the direct mode.
|TALEND_TOMCAT_SETUP||1 (true) if
||Controls whether to set up Tomcat with its default configuration or not. It must be true if Tomcat is provided by Talend. If Tomcat is already configured with specific parameters, set it to 0.|
|TALEND_TOMCAT_PORT||The default port is different depending on the installed application:
||Port used by Tomcat.|