Executing the Job to write and read data in Snowflake
After setting up the Job and configuring the components used in the Job for writing
and reading Snowflake data, you can then execute the Job and verify the Job execution
result.
Procedure
-
Press F6 to run the Job.
As shown below, the data is written into the table EMPLOYEE in Snowflake, then read from this table and outputted on the console in the Run view of the Studio.
Did this page help you?
If you find any issues with this page or its content – a typo, a missing step, or a technical error – let us know how we can improve!