Skip to main content Skip to complementary content

Preparing your installation

Procedure

  1. In order to install Talend Change Data Capture modules, you need to follow the three steps and the diagram below:
    • Step 1: Make sure your source database(s) are installed and configured on the OS of your choice, according to Hardware and software requirements for source databases.
    • Step 2: Install Talend Change Data Capture Manager GUI on Windows NT Server and the source engines.
      Information noteNote: The Manager and the source databases can be installed on the same machine or on separate ones.
    • Step 3: If they were not already installed at Step 1, install and configure your target database(s) on the OS of your choice, according to Hardware and software requirements for target databases.
    • Step 4: Make sure port 1310 allows inbound and outbound communications on the Manager and the engine machines.
      Information noteWarning: For security reasons, make sure your machines are in a private network (LAN or VLAN for example).
  2. To install your Talend product, you need to download your license key file and the relevant software packages:
    • Your personal license key that you received by email.

      This file has no file extension, and it is required to access each Talend module. Keep this file in a safe place.

      You will need it when adding a license.

    • The software packages that correspond to the Talend Change Data Capture modules you need to install.
      • Setup.exe for the installation on Windows.
      • SetupAS.exe for the installation on AS/400 IBMi.
  3. There are several ways to get help and support for your Talend installation:

In this section

Did this page help you?

If you find any issues with this page or its content – a typo, a missing step, or a technical error – let us know how we can improve!

Leave your feedback here